Pathway eDIN LED Dimmer modules provide DMX512 control over LED fixtures, with features such as user-definable MIN/MAX output, panic override, 0-10VDC auxiliary inputs and a "DMX present" relay.

Smooth fading, absent from many DMX LED controllers, is assured with an integrated 2,000 step fade processor. Current-sinking control allows each output LED zone to operate at a different voltage.  The DIN form factor makes installation, either in Pathway eDIN enclosures or your own cabinets, fast and easy.

The 1008 eDIN is a dimming interface, independent of the LED fixture and its power supply.  The 1008 will work effectively to dim any constant-current, non-dimming power supply feeding common-anode LEDs.   LED fixtures should only be connected to the power supplies recommended by their manufacturers.

The #1008 can also be used to drive components such as solid state relays and solenoid coils.

Features

• *NEW* User-set Grand Master maximum output
• *NEW* User-set minimum output - even after loss of DMX
• *NEW* 0-10VDC analog input auxiliary control
• *NEW* DMX present relay
• *NEW* Dry contact closure "panic" override input

• 6 DMX controllable variable DC outputs
• Output 5-30VDC (external supply required)
• Asynchronous 300Hz pulse width modulation
• Powerful fade smoothing to 2,000 steps
• RDM support for discovery, remote addressing, and firmware update
• LED display and pushbuttons for configuration
• 1500V DMX input opto isolation with self-resetting 250V fault protection
  
• 2500V isolation between all outputs protects against accidental grounding of fixture wiring
• End-of-line termination switch
• Status LEDs for power, DMX input
• Pluggable screw terminals for all connections
• DMX pass-thru connector
• Snap-on DIN rail housing
• DIN rail mounting section included
  

Model Description

Specifications

Accessories